D-1500.2

D-1500.2 is a stereo high power digital amplifier featuring 1500W per channel into a 4Ω load. It has been designed to amplify subwoofers or 2-way speakers.

 

  • 1500 W x 2 /4Ω
  • Class-D
  • Switching power supply
  • 2Ω load
  • Built-in Crossover
  • Stereo /Parallel /Mono /Auto Standby modes

 

Make an enquiry
D-1500.2 is a stereo high power digital amplifier featuring 1500W per channel into a 4Ω load. It has been designed to amplify subwoofers or 2-way speakers. Using a high current switching power and Class-D amplification modules, D-1500.2 offers high power efficiency with reduced noise and distortion. D-1500.2 can drive 2Ω loads. In bridge mode the output power reaches 2500W / 4Ω. A built in cross-over filter can be adjusted for cutoff frequencies from 50Hz to 250Hz. 4 Dip switches selects preset modes like Stereo, Parallel, Mono Bridge and Auto Standby.
MODEL D-1500.2
Power (Both channels driven) (RMS) 1250W x 2
(RMS) 1500W x 2
(RMS) 800W x 2
Bridge Mono Mode (RMS) 2500W
(RMS) 1000W
Input Sensitivity (Limiter Off) 0.9 - 1.1V (+0/-1dBv)
Input Impedance 20kΩ balanced or 10kΩ unbalanced
Frequency Response (At 10dB below Rated Output Power) 20Hz~20kHz (+0/-1dB)
Voltage Gain 40dB (+/-0.5dB)
THD + N (Ref. 1kHz 1/8 Rated Power, A-Weighted) <0.1%
S/N Ratio (Ref. 1kHz, A-Weighted) > 100dB
Crosstalk (Below Rated Power) > 70dB
Damping Factor (1kHz, 8W) > 200
Power/Output Circuity Switching Power Class-D
Protections Full short circuit, open circuit, thermal, ultrasonic, and RF protection stable into reactive or mismatched loads, turn ON/OFF, muting, tried crowbar
Controls Front: AC switch, Input level control for each channel Rear: Pre-set selector, SUB-X-OVER selector
Indicators SIGNAL : 2 green LED
CLIP :2 red LED
POWER/STANDBY: 1 changeable LED
PROTECTION: 2 red LED
Connectors Inputs: Balanced XLR or ¼‘‘ TRS
Outputs: Speakon
Power Supply AC:110~120V or 220~240V 50/60 Hz
Dimension (W x D x H) 483 x 460 x 44 mm
Weight 8 kg