500.2

The 500.2 is a Class-H switching power amplifier dedicated to fixed installations. It features two independent 450W channels driving both 4 Ω loads and 70 V/100 V lines.

  • 450 W x 2 / 100 V / 4 Ω
  • Class-H
  • 70 V /100 V outputs without transformer
  • 4 Ω outputs
  • Balanced inputs
  • Band-pass filter

 

Make an enquiry

 

Category:
The 500.2 is a Class-H switching power amplifier dedicated to fixed installations. It features two independent 450 W channels driving both 4 Ω loads and 70 V/100 V lines. Unlike most of 100 V amplifiers, the 500.2 does not use any output transformer, so the signal fed to the speakers is pure and natural. In addition, it uses a Class-H technology which gives a significant loss of weight and a gain of efficiency. One of the most popular applications is having two independent zones including low impedance loads on channel 1 for proximity speakers, and 100 V line on channel 2 for long distance transducers. All connectors and settings are located on the rear panel. Control Leds on the front panel give a real time status of the amplifier. A switchable band-pass filter can eliminate hum and noise on the 100 V line when necessary. The balanced inputs features XLR connectors and the outputs got screw terminals. A time delay protects the loads from current transients when the power supply is switched on. The amplifier is also protected against overvoltage, short circuit and overheating.
MODEL 500.2
Power 450W x 2
Amplification Class-H
Outputs 4Ω, 70V,100V
THD (1 kHz/-3 dBv) <0.1%
S/N Ratio (Ref. 1kHz, A-Weighted) > 95dB
Crosstalk (Below Rated Power) > 60dB
Input Level (balanced, 1 kHz) 0 ± 1.5 dBv
Input Level max.  (balanced, 1 kHz) 20 dBv ± 1.5 dBv
Frequency Response (L/H Filter OUT) 20 Hz – 20kHz  ± 1 dB  /  (L/H Filter IN) 100 Hz – 16 kHz  ± 1 dB
Connectors Inputs: XLR balanced Outputs: Screw terminals
Power Supply AC: 115~230V 50/60Hz
Dimension (W x D x H) 483 x 350 x 44 mm
Weight 6.9 kg