The 125.4 is a Class-H switching power amplifier dedicated to fixed installations. It features four independent 125 W channels driving both 4 Ω loads and 70 V/100 V lines.
Unlike most of 100 V amplifiers, the 125.4 does not use any output transformer, so the signal fed to the speakers is pure and natural. In addition, it uses a Class-H technology which gives a significant loss of weight and a gain of efficiency.
One of the most popular applications is having two independent zones including low impedance loads on channel 1 and 2 for proximity speakers, and 100 V line on channel 3 and 4 for long distance transducers.
All connectors and settings are located on the rear panel. Control Leds on the front panel give a real time status of the amplifier.
A switchable band-pass filter can eliminate hum and noise on the 100 V line when necessary.
The balanced inputs features XLR connectors and the outputs got screw terminals.
A time delay protects the loads from current transients when the power supply is switched on. The amplifier is also protected against overvoltage, short circuit and overheating.
| MODEL |
125.4 |
| Power |
125W x 4 |
| Amplification |
Class-H |
| Outputs |
4Ω, 70V,100V |
| THD (1 kHz/-3 dBv) |
<0.1% |
| S/N Ratio (Ref. 1kHz, A-Weighted) |
> 95dB |
| Mode |
DUAL / MONO (Ch1 & 2) and (Ch3 & 4) |
| Crosstalk (Below Rated Power) |
> 60dB |
| Input Level (balanced, 1 kHz) |
0 ± 1.5 dBv |
| Input Level max. (balanced, 1 kHz) |
20 dBv ± 1.5 dBv |
| Frequency Response |
(L/H Filter OUT) 20Hz~20kHz ±1dB /
(L/H Filter IN) 200Hz~10kHz ± dB |
| Connectors |
Inputs: XLR balanced
Outputs: Screw terminals |
| Power Supply |
AC: 115~230V 50/60Hz |
| Dimension (W x D x H) |
483 x 353 x 88.5 mm (19” x 13.9” x 3.5”) |
| Weight |
9.2 kg |
